Bed Mat

Looks good, but IMHO 3/8" is a lot thicker than it needs to be. You don't really need it for cushioning, just for anti-slip. If too thick it can add to "top heavy" issues you may have. I see that as being the only possible downside.

Nice mat.

I think its perfect.
My truck came with a Turbo-Liner bed liner so I saw no need to add anything else.

I have a sprayed in liner and use a mat. In addition I had to add wood slats under the camper to achieve the proper clearance.

I would guess my mat is about 3/8" thick. It is heavy and has lasted for 9 years with no signs of wearing out.

Looks good to me too. I just use a basic rectangle shaped rubber mat, it still looks and works like new on its 8 summer season.

I have the same mat in my F350. Works great and is a perfect fit. Much lighter than stall mats. My Igloo rides on it just fine. Good choice.

I have factory mat on my F350 and it works perfect.
It is heavy, but then I don't have to worry about wind picking it up. On previous truck I had like 3/8" thick rubber mat and I had to roll it each time I took camper off.
The TC I used had metal flashing with screws at the bottom, what would wear holes even in spray on liner.

Slymer wrote:
Looks good, but IMHO 3/8" is a lot thicker than it needs to be. You don't really need it for cushioning, just for anti-slip. If too thick it can add to "top heavy" issues you may have. I see that as being the only possible downside.

Huh?
You’ve seen rubber bed mats that are considerably thinner??

$20 says you can’t tell the difference in 1/2” of center of gravity.

Thanks for all of the replies. I hope to put in a couple of offers for a new camper this week. I have the hardware for mounting it along with the fast guns. I finally got around to opening the boxes up and found I got 2 sets of rear hardware and no front.

Rick

I kinda wish I had gone with that 3/8 mat instead of the 3/4 horse mat I bought..I was worried about clearance for my clearance lights on the cab..The horse mat is kinda a pain and very awkward to handle so I cut it in half making it easier to handle..

The truck camper you get will dictate how much height you will need for the TC to be clear of the rails and roof of your truck.