schlep1967 wrote: It will if the battery is connected. Without the battery the converter doesn't put out enough to run the motors. The converter charges the battery so the reserve power is there for the big DC draws.
My converter puts out 60A peak, several times what the slide motor requires (it's on a 20A automotive fuse so it's less than 20A for any significant amount of time). I've read that the hydraulic pumps used by some big rig slides need up to 100A which would obviously be more than almost any converter could supply.
2019 Dutchman Kodiak 293RLSL 2015 GMC 1500 Sierra 4x4 5.3 3.42 full bed Equalizer 10k WDH
LScamper wrote: So the slide works with the battery alone with nothing coming from the converter? That would be the same as the reverse polarity fuses being removed. The fuses are not needed to use the slide! So bad fuses will not stop slide from working.
On mine, power to the reversing solenoid for the hydraulic pump is wired direct from the battery thru an auto reset circuit breaker. But the 12 vdc power to the switch to operate that solenoid is wired from the converter/12v fuse panel. Thus the slides will not work with blown reverse polarity fuses since you cannot operate the solenoid.
So the slide works with the battery alone with nothing coming from the converter? That would be the same as the reverse polarity fuses being removed. The fuses are not needed to use the slide! So bad fuses will not stop slide from working.
It will if the battery is connected. Without the battery the converter doesn't put out enough to run the motors. The converter charges the battery so the reserve power is there for the big DC draws.
LScamper wrote: Maybe blew reverse polarity fuse but that should not stop slide from working. There should be a self resetting circuit breaker near the battery. That maybe toast.
Since the reverse polarity fuse stops all battery power from getting to the converter, the slides will not operate until it is replaced. At least that is how it is on my unit. Others with hydraulic slides may be set up differently.
Maybe blew reverse polarity fuse but that should not stop slide from working. There should be a self resetting circuit breaker near the battery. That maybe toast.
check the reverse polarity fuse(s) on the output of the converter.
Regards, Don My ride is a 28 foot Class C, 256 watts solar, 556 amp-hours of Telcom jars, 3000 watt Magnum hybrid inverter, Sola Basic Autoformer, Microair Easy Start.
You blew the converter fuses. Generally there are 4 of them usually between 20-30 amps. They are directly on the converter, not in the power center with the others.
Huntindog 100% boondocking 2021 Grand Design Momentum 398M 2 bathrooms, no waiting 104 gal grey, 104 black,158 fresh FullBodyPaint, 3,8Kaxles, DiscBrakes 17.5LRH commercial tires 1860watts solar,800 AH Battleborn batterys 2020 Silverado HighCountry CC DA 4X4 DRW
