Sirius radio hookup

I don't think you can splice the Sirius antenna cable and have it work correctly. You might be able to use your frig vent to run the cable.

Is the Sirius antenna removable? What connector does it use, what impedance is it?

TV wiring is 75 ohm, which is seldom compatible with anything else radio based.

My experience is that the satellite radio antennae come prewired and splicing is no advised. I used a magnetic-base vehicle antenna on mine. I have a roof vent location close to where our entertainment center is, and the vent has a Maxx-Air cover on it.

I got a large fender washer and attached it to the top of the Maxx-Air cover with hot glue. This was the highest point on the trailer, and the magnet mount antenna holds nicely on the big washer. Then route the wire around the vent, and you can get past the inside flange to get the wire in the ceiling and then take it to where you need it. I brought mine down the wall of the entertainment center and left about 6" of wire on the counter top to connect the receiver when I need to. Note there is NO need to disturb any of the sealing around the vent and the roof.

popsicleped wrote:
Hello. I have a Keystone travel trailer. I am trying to find a way to install a Sirius radio antenna on the outside of the unit.

Since my ent. cntr. is next to the dinette, I ran the portable antenna wire under a cushion into the storage compartment below where the antenna is stored. To use, I take it out through the outside cargo door and put it on the electrical box, back bumper, tongue or toss it up on the roof. Trees will block a signal and I like being able to position the antenna for best signal.

Teach

the antenna does not have to be outside to get a signal unless your roof is metal. mine works fine inside a cabinet just below the ceiling. you may have to adjust the angle a little depending on where you are . try it inside first you have nothing to loose trying it.

it may work to use the rg6 cable to hook the antenna to even with the mismatch in cables but you would have to cut the Sirius radio antenna cable and convert the ends to 'f' coax connectors the Sirius antenna cable is very thin and it would not be easy. and i do not think you will find any adapters from 'f' to the Sirius radio antenna connector.

Lots of good ideas here! Thanks! I will take a better look at what I can do in the spring. Thanks for the help

What kind of radio is involved?

An automotive head unit type should have a removable antenna, therefore an extended cable could be found on fleabay.

I run the slide part way out & fish the antennae lead outside, then open the slide fully.

Since I didn't use the AM/FM part of my TT's built-in stereo, and the antenna was directly above the stereo, I removed the AM antenna, fished the Sirius antenna's wire through the hole to the stereo compartment and then out a hole I drilled in the cabinet, to the car kit base. I also lucked out that the stereo had an AUX input in the back, so the Sirius car kit output goes through the same hole and plugs into the AUX input.
As BurbMan did, I also glued a fender washer(to the sub-roofing in my case). I used Dicor all around to seal it. I haven't had a leak in 4 years. Of course, I check it every year and add Dicor if it even looks as if it might leak.