karthuntr
Explorer
Joined 11 years ago
User Profile
User Widgets
All Activity
Re: Only half my electrical outlets work
I had the same issue with mine. I was getting 120V at gfci in bathroom but would not charge the vacuum. I also didn't have any power to any of the outlets in the slide. It ended up being a bad GFCI. Replaced that and everything was good to go. It was tight getting a residential GFCI in that tiny little box, I had to use an extension cover.1.6KViews0likes0CommentsRe: Prowler Slideout Help
Well I didn't bother calling them. I went back out and looked at it again and thought I would give it shot. Went very smoothly. After I figured out how to get to all the bolts and get vice-grips on the nuts on the back-side of the bolts, it came out smoothly and went back it almost as smoothly. FYI you do have to jack up the slide but just a 1/4" or so, just enough to get the through bolts lined up. I had the slide out 3" or so. Bearings on the gear pack were completely gone lots of play in the mounting plates. The slide runs so much smoother and it's quiet, faster too. Well worth the 80.00 for the part and 45 min. of labor.238Views0likes0CommentsProwler Slideout Help
My slideout, on my 2006 Prowler Lynx, has been squealing when going in and out since I bought it a year ago. I finally had time to crawl under and look at it. I had to cut the coroplast so I could access the gear pack. I lubed the one that was squealing with some dry silicone lubricant, which took care of the noise. I went to lube the other one and found the bearing on the gear pack (think brass bushing)was missing and just flopping around in the mount. I ordered the gear pack and should be here on Friday. My question is how the heck to I replace it. I have searched the forum and the internet and can't find anything relevant. Its a Lippert Slide (I think) and is fairly easy to access, I'm just not sure weather I have to support the slide, jack it up slightly or whether the slide should be in or out or somewhere in the middle. I am extremely handy, jack of all trades master of one(I have my master HVAC). I think Weird Al wrote the song Handy for me. :)933Views0likes5CommentsRe: Blower on my furnace keeps running.
My heater had the same problem. The relay on the board that turns the fan on was stuck. Its a closed relay but I was able to tap the relay with the back of a screw driver to unstick it and haven't had any problems since. If it continues you will have to replace the board.354Views0likes0Comments
Groups
Travel Trailer Group
Prefer to camp in a travel trailer? You're not alone.Jan 21, 202544,029 Posts
