All ActivityMost RecentMost LikesSolutionsRe: 99 Chieftain 5.9 Cummins wont stay runingHere is the update I blew fuel line out back to tank replaced sediment bowl on first filter primed the system and it will stay running now.Re: 99 Chieftain 5.9 Cummins wont stay runingGreat read on the VP44 pump path1Re: 99 Chieftain 5.9 Cummins wont stay runingYes I have the same thing I'm going to start again today I just have to take care of a few other things I will up date.Re: 99 Chieftain 5.9 Cummins wont stay runingI will look at the fuel drain valve on the side of filter housing on side of engine.Re: 99 Chieftain 5.9 Cummins wont stay runingI hope some body can come up with a diagram of the fuel system I do not believe it has a priming pump.Re: 99 Chieftain 5.9 Cummins wont stay runingYes I have been all over it today it acts like it is either sucking air or a line restriction.99 Chieftain 5.9 Cummins wont stay runingEngine was running with reduced power so I changed filters it seemed to not be picking up fuel so I changed lift pump same thing if I get system primed it will run for a few minutes then die if you pull filter not on engine it is not full it acts like it wont pick up fuel from tank it has 3/4 does the supply line just go into tank or does it have some type of screen on the end can I blow air down the line.Re: Slide Adjustment Water getting inThanks for the replies' I will be working on it this week as we are taking a trip in 2 weeks.Re: Slide Adjustment Water getting inSlide topper is not holding it back. After closer inspection looks like I need new rubber seal up top there is a gap at bottom on that end. Along with installing my new topper that I have.Slide Adjustment Water getting inWinnebago Chieftain on the top side one end of slide is not going all the way out I'm getting a little water inside if I get on ladder I can pull it out a little further. Is there any adjustment I can Make to make it seal up top better it appears end toward driver is sealed. I have a slide topper was getting ready to replace fabric when I noticed slide was not seating up top.