OK, got the instrument panel out but now I have a problem. The screws that hold it in were 8-32 which are too small to thread into the panel, 10-32 are too large. M4 is too small and M5x80 will only go in about a turn. What is this? Thanks!
I need to remove the instrument cluster for repair but first I need to know how to access it. Is the dash hinged? Is it fastened with screws? Velcro? Is it doable? Thanks in advance!Moved from FORUM TECHNICAL SUPPORT
I have a 2005 bounder 35E with a four door norcold refrigerator. The freezer makes ice but the refrigerator only cools to 50 degrees. I removed the external vents and found two fans. The forward one was blowing but the aft was off. The question is a...
The driver side slide on my 2005 bounder 36e is stuck. After the slide is fully extended it can only be retracted a few inches then stalls. Is there an adjustment to raise the slide over the floor so it can continue retracting?Thanks!
OK. I think the original screw was a M4.5 X ? Anyhow I am going with what the previous owner had ie. an 8-32 with a nut. Consider this thread closed. Thanks for all the replies!
OK, got the instrument panel out but now I have a problem. The screws that hold it in were 8-32 which are too small to thread into the panel, 10-32 are too large. M4 is too small and M5x80 will only go in about a turn. What is this? Thanks!