All ActivityMost RecentMost LikesSolutionsRe: 2008 allegro bus changed out king dome for weigand t4Doug and Bill, Thanks for your response, please excuse for not getting back, had a little problem just getting back to RV, disconnecting everything today. I can hear weingard searching and stopping has to be tuner connections. ThanksRe: ONAN 8500 TRIPS WHEN I TURN ON 1 AC UNITMr. Wizard Thank you going to rv tomorrow, will give it a shot how about a weak breaker on onan. Thanks JohnONAN 8500 TRIPS WHEN I TURN ON 1 AC UNITOnan 8500 generator trips after starting 1 of 2 ac units, units run ok on shore power, has 9500 hrs. also have to use aux power when starting. Thanks for any help JohnRe: 2008 allegro bus changed out king dome for weigand t4Disconnected all controllers, switchers and power supplys from old kingdome to new T4 traveler ran new CCTV cable from new antenna along with 12+ got no action on antenna, had no luck couldn't make it work. Thanks for your helpRe: 2008 allegro bus changed out king dome for weigand t4thanks you guys just landed at bus going to operate now. will let you know. Its my grandsons birthday and one of his birthdaywished he could go to jets game tomorrow and tailgate JohnRe: 2008 allegro bus changed out king dome for weigand t4Doug it is a 2008 allegro bus, 40 ft.Re: 2008 allegro bus changed out king dome for weigand t4Doug Thank you so much, I had thought it was a simple installation looking at drawing from weingard it would have been if I knew were tuners were. headed over there in a little while. I'll let you know. Thanks, John2008 allegro bus changed out king dome for weigand t4have 2008 allegro bus removed kingdome unable to get weigand T4 antenna operating, there is a tuner box on drawing for kingdom that everything is connected to that cable is connected does anyone know where this is located. Thanks JohnRV 40ft storage around mariatta, georgiaLooking for recommendation for rv storage for about a month indoor ok around Marietta Georgia. Thanks JohnRe: 2008 allegro bus leveling post have to replaceThese are electric legs I replaced leg, easy to replace plugged everything back in rear leg would not go up unplugged and switched to other leg in back something happened followed all instruction to reboot nothing works jut saw switch on diagram maybe this is our problem. Thanks for your help John