Dealing with bad power

For RV'ers the step-up - step-down booster buckers really are the best deal going.

Back in 1990 I found near the Phoenix airport a surplus dealer who had three beige steamer trunk size ferroresonant SOLA voltage adjusters. 270 lbs each. Out of the carton no instructions but all of the punch holes were in place. The surplus seller was adamant -- $400 each as is where is. Cash and carry.

Turns out they were top of the line +40% -40% line voltage correctors. I could only afford one. 168 volts going in? 120 out. 72 volts going in? 120 out.

But there's a glitch. Correction like this takes watts. 133 to be exact. 133 watts sitting there with 0.0 watts going out. 333 kWh over a 60 day billing cycle. And we are allowed 450 total in summer without going into excedente for another 150 hours then into DAC Data Alta Consumo which eventually reaches to above forty US cents US per kWh and applies to the entire CFE bill for months before automatically reverting to "normal".

I was crushed, the grand plan had a fatal flaw. For my in wall 5,000 BTU Gold Star I ended up with a Tor-Rey 2,000 watt unit just like described in this thread.

Need one in a strange city? Ask for the place that repairs refrigeration and well motors -- they'l have them in stock.

Hi snarley,

Is there more than one pot? Could you tell me where it is? (A picture would be wonderful).

snarley wrote:
This what I posted last spring -after the adjustment it really did give the 110 v we wanted . PM me if you want more info

snarley wrote:

Three of us bought these in Mazatlan and spliced them into our 30 amp extension cords. We also learned that here is a small single turn pot on the circuit board so we could adjust the switching points as ours seemed to switch about 108 rather than 110v. Otherwise , I can confirrn that when you add a heavy load at 115 v, the voltage drops for an instant and then boosts to 120. Highly recommend this for Mexican electrical systems.

This what I posted last spring -after the adjustment it really did give the 110 v we wanted . PM me if you want more info

snarley wrote:

Three of us bought these in Mazatlan and spliced them into our 30 amp extension cords. We also learned that here is a small single turn pot on the circuit board so we could adjust the switching points as ours seemed to switch about 108 rather than 110v. Otherwise , I can confirrn that when you add a heavy load at 115 v, the voltage drops for an instant and then boosts to 120. Highly recommend this for Mexican electrical systems.

When did you have your mishap Tequila? I don't remember reading about it.

YIKES

neither can I. Still have a concussion, however, and a sore neck. And a working regulator. My inverter did not survive. They recoversd itbut it no longer works.

Still can't believe you two walked away from that. Glad you did!

pianotuna wrote:
I chose to mount a 30 amp female and 15 amp female on the Sola basic box. I added another female outlet on the input side of the SB. That allows me to monitor output voltage and input voltage on the SB.

It also allows me to add basic surge protection to the SB on either the input or output side.

That is the neatest way to go. My instructions are for caravan customers with little experience in wiring to wire one up enroute.

In answer to the other question I am not sure where the adjustment pots are.

Mine survived a serious accident(3 rollovers) and still works, albeit with a dent or 2.

Nice work Tequila. Kudos!

I chose to mount a 30 amp female and 15 amp female on the Sola basic box. I added another female outlet on the input side of the SB. That allows me to monitor output voltage and input voltage on the SB.

It also allows me to add basic surge protection to the SB on either the input or output side.