LED lights

I ran the wire under the arm of the awning where it mounts to the FW.

I always mount them to the camper below the gutter, drill hole thru the side and mount the remote above or inside a cabine and tap into a 12volt line in the rig and not use the power supply that they sell for the light strips. Also I add 3m auto trim dbl stick tape to the strip before mounting and never have one come off. The tape on the strips is way too weak.

Every camper is different. My old camper, I had to drill a hole and seal. If Ibwas to do it again, I woukd have gonebout the fridge vent and used the gutter. My new camper, I used the hole for the current white LEDs and the power awning wire and resealed.

Here's one You Tube Video.

YOU TUBE LED LIGHTS

There are many others available for ideas.