210 series leveling jacks joystick

There could be a reset on the circuit breaker feeding the pump.
That is if a resettable circuit breaker was used.
No, there is no reset on the HWH system.

benjicarr wrote:
Is there a reset button?

No reset button on this system. Doug

Is there a reset button?

Thanks a lot guys. This definitely helps me find the problem.

Two other options for you problem are.

1: No ground signal from the emergency brake.
2: Under the joy stick cover are 2 springs that make connection from the cover to the circuit board. The may need stretching or cleaning.
I have the same 210 system and have experienced both problems.

Richard

Solenoid is on the pump/reservoir assbly. Doug

My solenoid is mounted to the top of the pump tank unit.

I always grab my rubber mallet when I have a solenoid issue on the jacks or slides. Or starter, or even the back up camera. A good whack often gets it to work for me so I can deal with it at my leisure. Finding the right solenoid often isn't necessary either. Just being in the vicinity usually works. If it's a solenoid issue that is.

But, it's very satisfying to whack on stuff.

Is the solenoid located on the pump motor or the pump itself?

Thanks for the help guys. It's a 2001 Damon Challenger, 34 ft. The jacks are in the up position. I just can't get them to do anything. They were working fine and then nothing. Im gonna try your suggestions in the morning.