Lippert Hydraulic Leveling Problems

Question

I have a problem with my Lippert leveling system on my 2006 Damon Daybreak. The center green light on the control panel flashes and the jacks down light is on.
The hydraulic fluid level is topped up and all the jacks in in the stored position. I have talked to Lippert several time and have gone through all their test. the trombetta solenoid has been changed twice and the problem persists.
Can anyone offer help.
Thanks.

mountainair05 · Answer

Here is the only manual that I could find.

http://www.lci1.com/LIP/0021.pdf

First is the parking brake set. you said the fluid is OK.

Second are the battery OK. Meaning have you check the voltage at the battery. Looking for 12.67 or so. Not plug into shore power.

If plug in the shore power then in the 13.xx .

Which system do you have or is the attach manual the right one.

dougrainer · Answer

The Trombatta solenoid is not the reason. LCI uses a PRESSURE switch to indicate jacks retracted. IF that pressure switch does NOT see and sense the static pressure on the system the Down light comes on. Doug
http://lci1.com/images/Flyers/LIPSheets/leveling/0008-pressure-switch-flush-fill-fitting-change.pdf

from_the_soo · Answer

Thanks Fellows; The parking brake is set, and the voltage is 13.65 V.
I reversed the spade connectors at the pressure switch and the jacks down light went off but the green center light continues to flash and the jacks will not go down in auto or manual. Very frustrating.

ricklap · Answer

We had an issue with our lippard jacks as well.  Turned out the only issue was the cable to the Batt was not tight.

bullydogs1 · Answer

Call LCI tech support...get to Jeff Marner..he will get you anything you need.

Forum Discussion

Lippert Hydraulic Leveling Problems

5 Replies

About Motorhome Group

Related Content

Damaged hydraulic leveler hoses

Re-level 5er with lippert hydraulics

Right rear leveler not retracting fully

Hydraulic Leveling jacks not wanting to retract??

hydraulic levelers