Replacing Kwikee steps
Has anyone replaced a 3-step set of automatic stairs with a 2-step? I recently damaged my steps because they did not retract. Prior to that I noticed they sometimes didn't extend fully, and I was th...
Forum Discussion
Vet Man wrote:
Is the motor damaged? I had the same failure, bent the steps badly. I used a floor jack to hold them up while taking them out and putting them back. Price around on the internet prices very a lot.
I'm just back from the FMCA Great Lakes Rally and was in a seminar where that product was highly recommended. Apparently it's the shaft that runs from side to side that you lubricate with that product. He told us that if it had not been lubricated you can thoroughly spray with it with WD-40. The WD-40 was only to clean it. After that it should be lubricated with that particular lubricant.
