Steps not going down

Start by posting what make and model steps you have.

Two most common problems with electric steps are low battery and/or bad ground - check those. Also check the fuses. If those are OK you can check for "binding" by climbing under and pull the cotter pin that connects the linkage between the step motor and the step .. remove the cotter pin/round bar and the steps should move smoothly. You might try and energize the motor with the steps disconnected if nothing happens then you have to figure out whether you have bad switch, bad controller or bad motor. In the old days Kwikee used to have diagnostic pdf on their website .. not sure whether new owner continued the practice.

Checked for a fuse this morning, cant seem to find one? Its not in the dash with the others at least. Pouring rain and storming outside this morning, so I will have to wait to get back out there.

Not sure what model you have. Fleetwood?
Check you manual switch. Check your contacts in the door that sense the opening and closing of the door. Check to make sure the unit is getting power to it. (Fuse) Look underneath to see if it is binding on anything.

Check all 12V fuses first, then examine the door switch.