Direct TV Setup
Can I use a slimline 3 dish with a HR 24 DVR (living room) and HR 25 HD Receiver (bedroom). The base of the LNB arm has 4 connectors, which one is used? Am I correct in my assumption that I will nee...
Forum Discussion
If you are string to hook up more than 1 reciever on a SWM system you need a
Swm splitter (which has a green label on it)
swm lnb which has only one connector on it. May have 1 or 3 eyes
A kaku lnb can have 1 or 3 eyes but will have 4 coax connectors for 4lines to run
A power inverter without it no receiver will get signal
The set up for the swm system is the coax cable from lnb to the powerr side of splitter. Then the line that is going to the power inverter need to be connected to the splitter with the red dot on the connectoe end
H25 only works on the Swm system. Will not work on a regular kaku system.
Make sure that the hr 24 is connected to the sat 1 connection on the back of the reciever
Thefollowing dvrs are compatible. With the Swm system are R16;R22; and H20-H24
If y'all have any more questions about directive installation y'all can pm me since I was an installer
Swm splitter (which has a green label on it)
swm lnb which has only one connector on it. May have 1 or 3 eyes
A kaku lnb can have 1 or 3 eyes but will have 4 coax connectors for 4lines to run
A power inverter without it no receiver will get signal
The set up for the swm system is the coax cable from lnb to the powerr side of splitter. Then the line that is going to the power inverter need to be connected to the splitter with the red dot on the connectoe end
H25 only works on the Swm system. Will not work on a regular kaku system.
Make sure that the hr 24 is connected to the sat 1 connection on the back of the reciever
Thefollowing dvrs are compatible. With the Swm system are R16;R22; and H20-H24
If y'all have any more questions about directive installation y'all can pm me since I was an installer
