Forum Discussion
chiefneon
Jul 28, 2019Explorer
Lynnmor wrote:chiefneon wrote:
Howdy!
I recently went from a MDT 4400 International to a new Chevrolet 3500 DRW with EOM break controller. This my first time with a truck that has a OEM controller I’ve always used a Prodigy controller before. We are fulltimers and just before leaving out with our need truck our 5er was in to have new drum brakes on all three axles. When I hooked up for our first pull with this truck and the OEM controller even with the gain set at the highest level 10 I don’t seem to have much breaking. Not sure if it’s the controller or or what. Never had this problem when using our Prodigy controller.
“Happy Trails”
Chiefneon
New brakes need to go thru a burnishing process, report back after that has been completed.
Howdy!
I got over a thousand miles on them from Texas to Florida. You think that’s enough?
“Happy Trails”
Chiefneon
About RV Tips & Tricks
Looking for advice before your next adventure? Look no further.25,171 PostsLatest Activity: Oct 19, 2025