Camco Gen-turi generator exhaust system
Going to the Albuquerque Balloon Festival this Fall. RVs will really be parked close together and it is dry camping where we will be. Will be using our generator quite a bit. Does this system work a...
Forum Discussion
I made my own, just because I could and not to save money, which I didn't really. I have three pieces of 3" abs pipe and elbow and it really looks like the CAMCO version. The only thing I would do different is to have the elbow run about two inches up into the vertical stack for greater noise reduction. That version is or was available from CAMCO.
I made a yolk from some 3/8" birch ply and a suction cup for holding onto sheets of glass to mount it to the RV. It works great and I goofed one day while testing it out on the new rig,
I didn't get the suction cup and yolk assembly attached before I installed it and it only took a couple of minutes for the vibration from the Onan to cause the weight to loosen the exhaust pipe from the manifold. Now I have to fix that. But yes they are a good accessory.
I made a yolk from some 3/8" birch ply and a suction cup for holding onto sheets of glass to mount it to the RV. It works great and I goofed one day while testing it out on the new rig,
I didn't get the suction cup and yolk assembly attached before I installed it and it only took a couple of minutes for the vibration from the Onan to cause the weight to loosen the exhaust pipe from the manifold. Now I have to fix that. But yes they are a good accessory.
