Re-settable Circuit Breakers Wiring

1L243 wrote:
What's the purpose of the second breaker?

Probably a slide.

On our Rockwood, the second breaker is for the slides.

The second breaker in your picture has a much thinner wire coming out of it, so maybe it's not for a slide (or maybe just the usual bad design on an RV). Do you have a slide?

Steve

I notice that the top wire is same for both breakers.

On the left hand breaker is the top or bottom wire the one that runs to the battery?

Likely one breaker is for something that is "Always on" (or operated by a momentary switch) like the jacks and the other is the MAIN. which can be "Turned off" by the salesman (Battery disconnect) Switch inside the RV.

On mine one powers the hydraulic slide pump. The other powers everything else.

My son FW looks just like that. One for landing gear one for slide. The big red wire at the top of the left breaker is the battery. It feeds the right breaker. You can check by removing one wire.

Safest way is to disconnect the battery then disconnect the bottom wire on the right breaker then reconnect the battery and try the slide.

Usually the two biggest draws are landing gear and slide and they run through breakers like that

1L243 wrote:
What's the purpose of the second breaker?

Breaker is there to protect the wire. Different load = different wire = different breaker.

Do yourself a favor and replace both with Bussmann Hi-Amp with same ratings.

time2roll wrote:

1L243 wrote:
What's the purpose of the second breaker?

Breaker is there to protect the wire. Different load = different wire = different breaker.

Do yourself a favor and replace both with Bussmann Hi-Amp with same ratings.

Good point time 2 roll
I have seen that clicker type breaker go into melt down and take out wiring harnesses. When a fault happens the breaker heats a metal strip and the contact tips pop open. It cools and pops closed only to quickly heat up and pop open. Eventually the tips weld and wires go into melt down. Can't beat the manually resettable. They use them all over.... because they are cheap

The thought of it being for the slide never crossed my mind. (this is my first trailer with a slide) I tried to remove one of the wires from the relay on the right to test it but it was so tight or corroded that they would not come off. The lug actually came loose. So, since the slide doe's NOT work NOW I guess we know what the Relay is for. I am going to replace them with the Bussmann manual relays...

1L243 wrote:
The thought of it being for the slide never crossed my mind. (this is my first trailer with a slide) I tried to remove one of the wires from the relay on the right to test it but it was so tight or corroded that they would not come off. The lug actually came loose. So, since the slide doe's NOT work NOW I guess we know what the Relay is for. I am going to replace them with the Bussmann manual relays...

These are not relays, they're circuit breakers, most likely auto resetting.

Your right I knew that my fingers got ahead of my brain.