Refrigerator won't stay lit Rm2652

.

Will do. I bought their water heater board before and it was wonderful. This makes me a repeat customer for Dinosaur!

Just went through all this with that exact fridge. Just replace the board with a dinosaur board. That's most likely the problem, and if not, you've done a great upgrade anyway. I went through all kinds of grief and expense before replacing my board. Now have Dinosaurs on hot water heater, furnace, and fridge, and all are flawlessl now. Good luck!

dougrainer wrote:

The BOARD has no affect on cooling reliability and consistant colder temps. ALL it does is turn the Heat source ON and OFF, relying on the Inside Temp Sensor. Now the 30 second restart by Dinosaur is a neat feature, but it is extremely RARE for outside wind conditions to blow out the flame. Doug

Well, the new board has an auxiliary temperature adjustment pot on it that allows me to set a colder temperature than the front panel on the fridge alone, so yes it does have an effect. And yes it is rare for wind conditions to blow out the flame, but a 20+ mph wind directly into the fridge side of my motorhome will blow it out, as has happened on a few occasions. Both of these benefits of the new board are useful to me, so I posted them in the event they might be useful to the OP.

Flyfasteddie wrote:
I had similar problems a few years ago with my 1991 fridge. Everything else was fine but I would have random shut-offs on propane.

I replaced the board and not only did the problems vanish, but in a situation where a strong wind does blow the flame out, the Dinosaur board is smart enough to turn the fridge back on after 30 seconds or so, rather than just shutting down until you manually reset it (usually after being gone from camp for 8 hours)

The fridge also has much cooler and more consistent temperature control than it ever did with the original board. It was highly worth it for me.

The BOARD has no affect on cooling reliability and consistant colder temps. ALL it does is turn the Heat source ON and OFF, relying on the Inside Temp Sensor. Now the 30 second restart by Dinosaur is a neat feature, but it is extremely RARE for outside wind conditions to blow out the flame. Doug

Awesome. Thank you all.

I had similar problems a few years ago with my 1991 fridge. Everything else was fine but I would have random shut-offs on propane.

I replaced the board and not only did the problems vanish, but in a situation where a strong wind does blow the flame out, the Dinosaur board is smart enough to turn the fridge back on after 30 seconds or so, rather than just shutting down until you manually reset it (usually after being gone from camp for 8 hours)

The fridge also has much cooler and more consistent temperature control than it ever did with the original board. It was highly worth it for me.

Rm2607. Correction.

Yellow. $110 sure? I now no guar.

You still have the 1996? If so, LOOK at the rear control board. If all the circuits/resistors and such are encased in beige/yellow epoxy, the problem is the control board. Replace it. If the board is greenish epoxy then more testing is required. The OLD Dometic boards from about 1993 until 1998 were defective. Intermittent check light was the symptom. It could NEVER happen or it may be hours/days/weeks before it happens. In your case 20 years. Doug