Gluing on aluminium checker plate
Hey folks, First post here and I'm looking for help. I have a 2007 Jayco 20ft travel trailer. Before I bought it somebody closed the door while the latch was in place and broke a hole in the bottom o...
Forum Discussion
SidecarFlip wrote:Ralph Cramden wrote:
I would use 3M molding tape around the perimeter and a strip in the center, then caulk the edges with clear Geocel proflex.
I respectively disagree. Sikaflex adhesive and dicoe on the edges or Geocel, but Sikaflex to secure the panel. Liquid nails for an RV.
Got ya bud, used sika products before for lots of stuff. I stuck a 20" x 8' piece on a cousins Rockwood with the 3M tape, I believe it was .063 plate. He ran over a piece of cribbing and dinged it good, cracking the filon behind it. It took 30 minutes to cut it, stick it on and caulk it, and an hour and a half to get it off with a heat gun and by pouring solvent behind it. Sticky stuff.
