speakers that let water into RV wall

Thanks Towpro for info. I will be doing this project soon before our Florida trip.

Here you go, but don't think they have 5".

http://www.polyplanar.com/product/sbc2-8-12-speaker-back-cover


another one.
http://www.sonicelectronix.com/item_9441_Metra-81-4300.html

I just called cruthfield on these.

they said they are designed to keep any water that gets into your car door, off the back of your speaker.

He also reminded me that you still need a hole to get the wire through, but I guess you could seal that with silicone or something.

I need to see what kind of speaker is in there now (but camper is currently covered).
Wonder if putting true marine speakers in now is a good preemptive strike?

I am still hesitant about the foam pockets because I fear the foam edge exposed between the wall and speaker could act like a sponge and soak winter into the junction it is trying to protect.

I really would like to find something shaped like a pie plate but with a flat flange, made of plastic, that would fit the bill perfectly. I am as leery with speaker pockets marked "waterproof" as I am with speakers being "waterproof".

some of my Fear comes from the fact I also own an 2011 Open Range 5er that instead of using putty they used foam double sided tape to install all the trim over any siding joints. It leaks worse than any RV I have ever owned in 30 years of RV ownership

I also was directed to page 5 of that thread-
To share a post of a thread though, click on the Link button of particular post within a thread, copy the link displayed and paste that (as a link) it will direct to a individual post of a thread...
http://www.rv.net/forum/index.cfm/fuseaction/thread/tid/29008713/gotomsg/29013152.cfm#29013152

As far as the foam baffles, I doubt finding foam baffle hats less than 2" deep will be easy or really needed. As long as the back inside diameter of baffle is close to back of speaker diameter (magnet/housing), squashing the 2"- 2 1/2" deep foam baffle should be easy to fit depth. Material is very soft, maybe 1/4" thick, also compressible. You can wad these things up into a ball. I'd be more concerned with speaker flange compressing uniformly where the foam hat laps outside.

trail-explorer wrote:

CAJW wrote:
... See the 3rd post down for details here.

Outdoor speaker fix

uhhh.... the 3rd post says something about an Eagle Cap, and that is all.

Bob,
Not sure what you're seeing, but I checked the link again and it went to the intended page.

CAJW wrote:
... See the 3rd post down for details here.

Outdoor speaker fix

uhhh.... the 3rd post says something about an Eagle Cap, and that is all.

Towpro - If you haven't yet purchased the speaker boxes, you might want to try and find some that are 1 1/2" deep. The rear wall on our AF996 is 1 1/2" deep in which some foil backed foam insulation (1.5") fit like a glove. On the link you provided, I only saw a 2" being offered as the most shallow depth they had, which wouldn't fit flush. See the 3rd post down for details here.

Outdoor speaker fix

Great subject Towpro. Thanks for post. Will definitely look into this soon with our new TC. Keep us updated Deltabravo too.

as soon as the winter cover comes off, I will see how deep the hole is, and if there is enough room behind magnet for this new piece.