Took the plunge - Cummins to Hemi 6.4
After reading posts, reviews, specs, watching videos, and a few test drives, I finally decided to take the plunge. I sold my 2003 Ram 2500 QC LB 4x4 Standard output 5.9 Cummins 5 speed and bought a ne...
Forum Discussion
nirion wrote:Cummins12V98 wrote:
Set full forward with the straight edge forward on the side plates. Adjust to 6" from bed to RV. With my B&W full forward and 4,500# pin weight I add less than 200# to the front axle.
Do you have any issues on sharp turns or if you go off the paved road with it set that way? I have a toolbox that I will be putting in the truck this weekend and worried about getting too close to the front. Also, I don't have a driveway put in my property yet, so it is a little bumpy getting the trailer back in.
Not at all. My toolbox ia bed height and 30" front to back.
