Getting ready and found this!
I endlessly prepare to leave on a big trip--and occasionally actually do go. So yesterday I started thinking about checking my suspension and slid under the rear axle--just for a look. I was startled ...
Forum Discussion
Here's the subframe being welded up. It will be very strong and allow the hangers to be short. We are going to put triangular braces on the hangers as well. If we are doing all this, we might as well make sure it's not going to happen again. 
Notice that the cross bracing is the same as the subframe where the hangers fit. We are also putting a cross brace on the place of the middle hanger. It's just not on yet. Tomorrow we should be putting it in place and doing a lot of welding. We've had a big fire extinguisher on hand with all the sparks.
Notice that the cross bracing is the same as the subframe where the hangers fit. We are also putting a cross brace on the place of the middle hanger. It's just not on yet. Tomorrow we should be putting it in place and doing a lot of welding. We've had a big fire extinguisher on hand with all the sparks.
