Help from my WW Superlite Brothers

I have one.. I will have to do this Mod between Vet's weekend and the Giving of Thanks weekend...

Or for less weight and a bigger picture, hang one of these from your ceiling and install a roll-down screen. It only works in the dark though. :B

LowRyter wrote:
I purchased a new Weekend Warrior SL2805 that had the TV & radio cannibalized by the dealer. I had them install a swing mount from Best Buy. It is mounted to the right side of the original TV opening. The swing mount is reinforced with additional wood. They also mounted a diagonal strap to hold the TV in place while moving. I decided to just remove the TV and store it under the bed. Even with the mounting plate on the TV, it's flat enough to fit. This does require that I mount the TV, plug and attach the cables to use it.

I later installed a Jack Antenna which gives better reception than the old Omni. The 12v adapter works well too. I was able to dry camp and watch TV w/o running a gen. LCD TVs use very little power.

I do get tired looking up at it.

Perfect, the jack antenna was the next mod!!!

I purchased a new Weekend Warrior SL2805 that had the TV & radio cannibalized by the dealer. I had them install a swing mount from Best Buy. It is mounted to the right side of the original TV opening. The swing mount is reinforced with additional wood. They also mounted a diagonal strap to hold the TV in place while moving. I decided to just remove the TV and store it under the bed. Even with the mounting plate on the TV, it's flat enough to fit. This does require that I mount the TV, plug and attach the cables to use it.

I later installed a Jack Antenna which gives better reception than the old Omni. The 12v adapter works well too. I was able to dry camp and watch TV w/o running a gen. LCD TVs use very little power.

I do get tired looking up at it.

Well sounds like I am going to order up a couple of mounts and pull a fridge. I will post pics and start a new thread when ready!

derwud wrote:

How hard was it to pull the fridge?

It has been a couple years so I don't remember details but it wasn't difficult. Disconnect the LPG line, unplug the 120v, disconnect the 12v, remove a few screws and pull it out.

I placed some milk crates in front of the refrigerator for support. Had my son help me with the physical lifting/removing of the refrigerator, and we sat it on the crates. When time to reinstall I did it myself because although bulky it wasn't real heavy. I only had to lift it from the crates to the opening.

Although I don't own an FS, WW fridge installs should be close to the same. I removed my fridge to install wires in the vent and the control box for a Sat. dish. Mine had six screws around the front, open the doors and you will see the some of the screws. Then pop off the top fascia and 2 more screw will be visible. In the back remove two more screws that hold it down. You may have to remove the flame shrouding update if you had it done. Unhook the power wires and the gas line and then it will slide out. I put mine on a moving dolly and wheeled to the back of the trailer to clean it up somewhat. While you're in there WW didn't use the best insulation so I redid that too. I think it took me aobut a 1/2 hour it get it out. It's not real heavy just bulky and awkward to handle.

beemerphile1 wrote:
Since I hate looking up at a television I decided to locate it elsewhere. I mounted it on the wall under the television cabinet.

Since the wall where I was mounting is the refrigerator cabinet, I removed the refrigerator and reinforced the wall with plywood. I then through bolted a flat screen swivel mount.

I love it mounted on the wall. We can swing it anywhere we want for the correct viewing angle.

How hard was it to pull the fridge?

Since I hate looking up at a television I decided to locate it elsewhere. I mounted it on the wall under the television cabinet.

Since the wall where I was mounting is the refrigerator cabinet, I removed the refrigerator and reinforced the wall with plywood. I then through bolted a flat screen swivel mount.

I love it mounted on the wall. We can swing it anywhere we want for the correct viewing angle.

I did mine on a swinging mount like the others, but I added a zip tie so it wont swing. The one I really like is the one where someone made the TV swing up like a door. It even had the support things on it so it doesnt crash down. I have pics someplace, but I have no idea how to post them.