Help 2014 Fleetwood, where is tow brake adapter

You will have to call Fleetwood. Adapters are done at the REAR where the Ford chassis harness is located. You need to follow the Tow plug harness and see where it is interconnected. Doug

Ok rechecked fuses under engine compartment and all are good. Even checked two diodes all are good

Ok thanks. you are right, tail lights work but no signal or brake. I will check the fuses in that box again, but do you know where the adapter would be? I kinda think that's the problem is, but not sure

OK, The adapter only is for the Left and right turn and Brake lights. The running lights should still work. If the running lights do not work, then either the 7 way at the hitch is unplugged from the Ford Harness or you have NOT found the fuse box up front for the Tow plug wiring. Usually on Ford Chassis's the fuse block is accessed from the front outside hood and is mounted on the outside firewall in front of the drivers seat. Doug

Its a ford chassis 36 ft

It would help to know what chassis you have. Doug

I checked all the fuses. Even found the one marked tow brake. MH has red brake and orange signal

OK, first check all of your fuses for the chassis. Don't just look at them, actually remove and test them with a VOM. Do you have separate brake and turn lights, or does your MH use the same light for both the brake and turn lights? If it uses the same light, you do not need an converter. The fuse panel you are looking for is probably on the dash in the drivers side.

Oh, and welcome to the forum.

No. There is no power to brake lights or turn signal. There is no module at the back. I traced wire bundle about halfway up but then they disappear, my last mh the module was nice and handy at the back

Are the lights on the MH working in the back? The converter is usually near the receiver hitch underneath.