cancel
Showing results forย 
Search instead forย 
Did you mean:ย 

Starting my generator in my class C without

HARLYGL94
Explorer
Explorer
So they tell you to take the house batteries out and keep them on a trickle charger instead of keeping the whole class c plugged in all winter, but now I have a problem with starting my generator it seems it will not start without the house batteries even if I start the RV up or plug it into AC it will not start. And I was going to faithfully run it once a month for two hours. I guess it needs the juice from the house batteries to start or am I missing something here? what should I do now?

thank you
26 REPLIES 26

HARLYGL94
Explorer
Explorer
This is what I've been reading
Winter Battery Storage & Maintenance
October 12, 2009 by Mark Polk ยท 12 Comments Print This Print This ยท
battery 018I was recently asked a question and felt like the answer could be useful to lots of RVers, so I am using the question as the topic for this article.
Q: Hi Mark, we live in Colorado and we are preparing our RV for storage. I just had the RV winterized, but I am concerned about how or what to do to store my RV batteries. Any advice would be appreciated.
A: The two most common causes for RV battery failure are undercharging and overcharging. Undercharging is a result of batteries being repeatedly discharged and not fully recharged between cycles. If a battery is not recharged the sulfate material that attaches to the discharged portions of the plates begins to harden into crystals. Over time this sulfate cannot be converted back into active plate material and the battery is ruined. This also occurs when a battery remains discharged for an extended period of time, like during storage. Sulfation is the number one cause of battery failure. The second leading cause of battery failure is overcharging. Overcharging batteries results in severe water loss and plate corrosion. With that said letโ€™s look at how to properly store your RV batteries.
Before we talk about storing the batteries we need to talk about battery safety. Lead acid batteries contain sulfuric acid which is extremely corrosive and can cause severe burns or even blindness. And the hydrogen gas that batteries produce, when theyโ€™re charging, is very explosive. When you work around batteries you need to wear safety glasses and gloves, remove all jewelry and do not smoke or use any open flames.
Caution: If you accidentally get battery acid on your skin, flush it with lots of water and if it gets in your eyes flush with low pressure water for 15 minutes and call a doctor.
When you put the RV in long term storage itโ€™s a good idea to remove the batteries and put them in storage too. This is quite simple to do. The first thing we want to do is visually inspect the batteries for any obvious damage. Any fluid on or around the battery may be an indication that electrolyte is leaking from the battery. A damaged or leaking battery should be replaced immediately. Whenever you remove any battery always remember to remove the negative terminal or cable first, and then the positive cable.
Battery Tip: When you remove a battery turn off the ignition switch, all electrical switches, and any battery disconnect switches before you disconnect the battery cables. Whenever you remove any battery cables label them first so you remember how they go back on the battery next spring. When you reinstall the battery do it in the reverse order. Install the positive cable first and then the negative cable.
Clean the batteries with a 50/50 mixture of baking soda and water if necessary. Now you can check the electrolyte level in each cell and add distilled water if necessary. The minimum level required, before charging a battery, is at the top of the plates. If itโ€™s below the plates add enough distilled water to cover the plates before you charge the battery.
Test the battery state of charge with a voltmeter or hydrometer and charge any batteries that are at or below 80% state of charge. An 80% charge is approximately 12.5 volts for a 12-volt battery and 6.25 volts for a 6-volt battery. Lead sulfation starts when a battery state of charge drops below 80%. After charging the batteries check and fill each cell to 1/8 inch below the fill well with distilled water. Overfilling cells will cause battery acid to overflow.
Caution: Batteries should only be charged in a well ventilated area and keep any sparks and open flames away from a battery being charged. Check the electrolyte levels before and after charging batteries.
A discharged or partially charged battery will freeze much faster than a charged battery. Store the batteries in a cool dry place but not where they could freeze. Batteries in storage will loose a percentage of current through internal leakage. Itโ€™s not uncommon for a battery to discharge up to 10% a month when it is being stored. Cold temperatures slow this natural discharge process down and warmer temperatures speed the process up. Test the stored battery state of charge every month and charge batteries that are at or below an 80% state of charge.
Completely charge the batteries before re-installing them next spring. For optimum performance you can equalize the batteries after they are fully charged. Battery equalizing is a controlled overcharge on a flooded lead acid battery after it has been fully charged. Equalizing reverses the buildup of negative chemical effects like stratification, a condition where the water and acid separate and the acid concentration is greater at the bottom of the battery than at the top. Equalizing also helps remove some of the sulfate build up on the battery plates. Equalizing is fine as long as there is not excessive heating or electrolyte boiling over. Some battery chargers have an equalization cycle or charge setting. After charging a battery, set the battery charger on equalizing voltage and charge it again. You need to test the specific gravity every hour during equalizing. Equalization is complete when the specific gravity readings no longer rise during the gassing or bubbling stage. Keep in mind if equalizing a battery is done correctly the electrolyte should not boil over but it will create a good bit of bubbling, and when the cycle is finished you will need to add distilled water to the cells.
Note: If you donโ€™t feel comfortable working on or around lead acid batteries have battery maintenance done by an authorized service center.
If you decide to leave the batteries in the RV while it is in storage remember to check the state of charge monthly and charge any batteries at or below an 80% charge. If your RV converter charger charges the battery(s) at a constant rate (around 13.5 volts) this is too high for a float charge and can deplete the electrolyte over time. In this situation plug the RV in periodically and allow the converter charger to charge the battery(s) for 8 to 12 hours. Some RV converter multi-stage chargers and aftermarket chargers are designed to maintain a float charge on the battery without removing the batteries from the RV. Remember, for the converter charger to work the RV will need to be plugged in to electricity.
Watch a video clip on Saving your RV Batteries

tenbear
Explorer
Explorer
Like others I leave the batteries in the MH with a Battery Minder on the house battery and a trickle charger on the chassis battery. I run the genny every few weeks for an hour or so with my 1500W heater when it gets above freezing. I don't start the MH engine during the winter.
Class C, 2004/5 Four Winds Dutchman Express 28A, Chevy chassis
2010 Subaru Impreza Sedan
Camped in 45 states, 7 Provinces and 1 Territory

deltamaster
Explorer
Explorer
I think you need to run it under electrical load. I run it for about an hour every month or two when not in use and make sure to have the A/C or water heater on (with water in it) to draw a load.
:E [purple]I ride it like I stole it![/purple] :B

.......and I just may have.......



I'm on "CB-13", are you?



2004 Fun Mover with a 1998 Road King and a 2002 Sportster tucked in the garage, Dragging a 2002 "RAM Tough" Dodge Dakota Crew Cab. Ohhh what a haul!

TSgt(Ret.) USAF

ronfisherman
Moderator
Moderator
My motorhome is plugged in to shore power all the time at home. It has a multistage converter. Almost never have to add water to batteries. I see no need to remove batteries for storage. If you have access to shore power where your RV is stored. Use it. Then start generator and run under load monthly to keep it healthy.
You may need to add a trickle charger to keep chassis battery fully charged.
2004 Gulf Stream Endura 6340 D/A SOLD
2012 Chevy Captiva Toad SOLD

HARLYGL94
Explorer
Explorer
Yes you might seem to think that Starting it will do more harm than good but Onan recommends it and so many other people say that the Onan generators will fail if you do not start them. it's called exercising it so on one hand I do agree with you but I read so much extensively about the Onan generators that's why I feel the need to start it once a month.
As far as all the other winterizing engines I just use the fuel stabilizer in all of them and they start great in the spring.

eddard49
Explorer
Explorer
I own lots of stuff that has to be winterized, and we have some tough winters in Montana. I never start stored vehicles (motor home, motorcycles, riding mower)until the weather relents in about April. I use Seafoam as a stabilizer, fill the fuel tank, and apply a smart charger every 4 to 6 weeks. The smart charger is used on the coach and chassis batteries in place, and is easy to connect via the charge selection solenoid on the engine firewall.....one side of the solenoid for the chassis, the other side of the solenoid for the coach.

In my opinion, starting any vehicle and just letting it idle for 15-30 minutes does more harm than good. You're loading the exhaust system with moisture that isn't eliminated by just idling.

HARLYGL94
Explorer
Explorer
You keep them all connected but can you put the battery minder on it when it's connected? I thought in the Winnebago manual it said to disconnect them.

ksg5000
Explorer
Explorer
Many people don't' run their generator when the rigs parked for the Winter .. probably better if you do but it's not that big of a deal. Other alternatives would be to drain the fuel from the generator carb, add Seafoam or gas stabilizer, or let the RV gas get below 1/4 tank an let the Generator run until it's dry.
Kevin

aubreym
Explorer
Explorer
I also leave both the MH and engine battery in place. Both are connected to Battery Minders. I start the engine and the generator once a month and let them run for around 45 minutes. No problems so far.
- Aubrey W7OLY

Mandalay_Parr
Explorer
Explorer
Unless you rig is very old, I would leave it plugged in and check the battery water level once a month.
Jerry Parr
Full-time
2005 Mandalay 40B
Cat C7 350, 4 Slides
Blue Ox, Brake Buddy
2004 CR-V Toad
jrparr@att.net
602-321-8141
K7OU - Amateur Radio
Kenwood Radios
ARRL, W5YI, & LARC VE
SKYWARN Weather Spotter

Grandpere
Explorer
Explorer
I leave my coach batteries in the MH and run an extension cord to the battery charger that is hooked to them. I run the generator and the MH engine every week for 30 minutes, overkill maybe, but I do not have any problems with the generator or the engine and everything is ready when we want to go and camp. We camp year round, we just make adjustments for water and holding tanks in the cold weather.
Berniece & Russell Johnson
Lil'Bit, a Netherland Dwarf Rabbit
1987 Southwind
1995 Ford F150 Supercab

Life in the fast lane? No thanks, we will stop and smell the flowers at every opportuity

GENECOP
Explorer II
Explorer II
Some RV's have a switch that you can press, this switch will divert starting power for the generator from the house battery to the chassis battery or vice a versa.......maybe you have one.. It's a toggle switch that will snap back after you get the Genny started...