3000W Chinese Gensets Info.

professor95 wrote:

hbski wrote:
I found some heat/sound shielding mat from Pep Boys auto parts and it should be safer than that flamable moving blanket.

I am sure it would be safer. I did not know Pep Boys carried the stuff - I will check it out.

BTW, the moving blanket was there only for a brief test. I have no intent of using it on a more permanent basis.

I have my design worked out, the propane conversion parts and hardware to remotely relocate the muffler are all in-hand as well. All I need to do now is find the time to build it. I gathered a lot of data from the first generation design and realized numerous mistakes. I believe this (new) model enclosure I have been designing will finally give the results I want at a "somewhat" reasonable cost. Once finished and tested, I will post all results.

Well, the amount of moving blanket you had on that one side surely should have absorbed quite a bit of acoustic energy!!!

Please do post your finished product. I too have a design, just finding it hard to find the time to actually build it. Does your current design remove/replace the frame?

Cheers,

DJ