To those w/10 gal. water heater.

dougrainer wrote:


Bypass valves or outside shower will not cause an extremely long Heating cycle. Doug

Really? If the by pass is open or partially open it won't bleed cold into the hot side, and cause long heat time? The original post says waters not that warm.

https://www.youtube.com/watch?v=x1Vp6Kwp2Yo

Thanks for all the suggestions.
I will relay this info to Keith and see if they correct his problem. If he replies to me I will post the outcome.
Thanks again to all.

dougrainer wrote:

Edd505 wrote:

bdpreece wrote:
Couple of thoughts. As BFL13 stated check the bypass valves. Second thought check to make sure the outside shower is actually shut off at the valves rather than at the shower head.

My bet one of these fixes the issue.

Bypass valves or outside shower will not cause an extremely long Heating cycle. Doug

The rig is new, so I thought more likely the thermostat would be ok, but the owner is new to that rig.

I was thinking some cold water was getting in at the same time he was trying to heat it, delaying the heat up and it never getting fully hot.

I thought the by-pass valves might not be set right, but had not thought it through. So now my idea needs a new way for that to happen. Running water or a leak from the hot side? Not so likely with the water pump coming on. He would notice that! Or would it if on city water? He is in a "camp" in the OP.

Edd505 wrote:

bdpreece wrote:
Couple of thoughts. As BFL13 stated check the bypass valves. Second thought check to make sure the outside shower is actually shut off at the valves rather than at the shower head.

My bet one of these fixes the issue.

Bypass valves or outside shower will not cause an extremely long Heating cycle. Doug

bdpreece wrote:
Couple of thoughts. As BFL13 stated check the bypass valves. Second thought check to make sure the outside shower is actually shut off at the valves rather than at the shower head.

My bet one of these fixes the issue.

another thing for him to check is does the flame burn properly. does he have electric hooked up to it also, if so is he using it. I have a 10 gallon and I have real hot water just on electric. if I need lots of hot water I use them both at the same time

EXT is the Mixing valve Atwood, BUT, that would NOT cause a LONG time to heat. IF it runs for 2 hours and the water is NOT hot, then either the LP pressure is too low or the burner is not set up for correct flame. But if it shuts OFF after 2 hours and the water is NOT hot, that points to a defective tstat also. The tstat should not open until the water is 130/140 degrees. Doug

I know that some newer Atwood water heaters and maybe others have a mixing valve. This injects cold water into the hot water stream as it leaves the heater. Doing this allows a 10 gal water heater to super heat the water and provide more than 10 gals of hot water. Check the water heater model number to see if this heater does have a mixing valve. The valve may be defective or clogged.

Go outside, open the access panel door and lift the lever on the PT valve. If very hot water comes out, the problem is most likely with one of the shower control valves or the bypass valve. Check them for proper position. If the water is lukewarm you friend has a problem.

Couple of thoughts. As BFL13 stated check the bypass valves. Second thought check to make sure the outside shower is actually shut off at the valves rather than at the shower head.