All ActivityMost RecentMost LikesSolutionsRe: step control moduleLCI steps motor is faulty or check the gear ,it may have worn teeth and needs to be replaced, I just finished rebuilding my steps and replaced the motor, gear and all nuts, bolts, bushings, washers after having them sandblasted and epoxy painted. They now work better than new.Re: Record Low Temps in the KeysUp here in Winnipeg Canada it,s balmy -17 F so there!Gen will not turn ofI have a 2011 Georgetown 374 and the generator will not turn off with the main switch -- any suggestions ThanksANOTHER WINTERIZE ?I can run the antifreeze thru the cold water system, but with the valve for the inflow to the hot water tank of I get no run thru,do I have to fill the HW tank to get flow, there does not seem to be a by- pass valve. What am I missing. THANKSRe: Forest River 30DSI have a GT 2011 374 and all I can say is I LOVE IT. Purchased new,now has 20000 miles.Would buy another.Re: Bounder vs Georgetown XL vs SunseekerI have a 2011 Georgetown 374, purchased new, and love it. Would buy another Georgetown in a heartbeat.Hydraulic fluid levelI was checking hydraulic fluid but am not sure which mark on dipstick is correct, the fluid is at the 3/4" mark . There are 2 marks, 3/4" from bottom or the one about 3" up the dip. Slides and jacks are retracted.STEPS MAKING CLANGING NIOSEHope someone can answer this question. When the steps on my Georgetown go down they clank about 6 or 7 seven times, like the motor is engaged, then they are fine. They only make the noise when they are fully out. THANKS IN ADVANCE.Re: squeaky sliderIf you can give a description of the squeak that would help, is it something lose or rubbing. What is the slide housing, furniture, appliances?Re: What did you do to your Class A MH today???Just finished loading up the "BIG GIRL". Filling up in the AM and heading down to Florida for the winter. Going to take it easy and do it about 5 days.