12VDC Replacement Bulbs
Okay...so I'm normally pretty savvy on repairing/replacing stuff. The wall sconces in our coach had gotten pretty picky about when they wanted to come on and off, so after a little diagnostic work with a meter, I found that the little pushbutton switches on each sconce were bad or going bad. I ordered new switches from PPL, installed them and now I have an issue of which replacement bulb goes in which fixture. One fixture has one bulb, another has two bulbs....kinda like the door locks and bin locks...there was apparently no consistency when they built this thing so I have a grabag full of bulbs left from the previous owner.
Any rhyme or reason to which bulb to use where? And before you say it, no....there is no writing or marking on the bulbs themselves. I can try to match up the shapes, but in the autoparts store they may LOOK the same, but some are lower voltage or have a different connection.
Any rhyme or reason to which bulb to use where? And before you say it, no....there is no writing or marking on the bulbs themselves. I can try to match up the shapes, but in the autoparts store they may LOOK the same, but some are lower voltage or have a different connection.
