rocker switch

The center pins should go to the blind. Power should go to ends of switch and be criss-crossed to other end pins reverse blind motor.
Found good photo off back of switch Reversing switch

I put in new switch and it still won’t work it just winds the blind up tight won’t bring it down I am it a lose!
Now the wife just tell me the other blind only goes 1/2 way bown don’t know

Switch should be a momentary on/off/on double pole-double throw. It needs to reverse the DC to the blind.

Try this... Cycle the switch UP/DOWN UP/DOWN like 100 times while it is NOT connected. then re-connect and try again.
If it does not work, well at least it was FREE
if it does work consider
"Should I buy lotto tickets cause when you hot, you hot"
or
"Should I NOT buy lotto tickets because i used up my quota of LUCK for the month"


Worked for me, in Las Vegas, different switch and I did fairly well that week, Did not win big but did not lose either.

1-800-322-8216 I called this no. And got the rite switch!

Colaw in Missouri
colaw
Same switch you have should have the 6 pin depending on manufacturer. What switch did you get? Part and manufacturer?

Got the new switch it doesn’t work new switch has 3 terminal on it my switch has 6 terminals on it.
Is there a RV.salvage yards out there?

yes found it by using the US.pattan number.

Are you saying you successfully found a replacement switch?

I looked again and I saw no. on the other side it was the Pat. no put that in and it took me rite to it got one