Propping exit windows open

I may try an extension. I am going to try to get a hinge/latch like om the side of an A frame ladder. Then it can open it and lock it open. Just a thought. If that doesnt work I am goiong with the prop idea.

To the OP: could you fabricate an "extension" for the existing prop rod ? Something that would simply make the factory prop maybe twice as long.

Jeffzee160 wrote:
This thread gave me an idea. I couldn't use baggage door latches because my window hinges don't swing up past 90 degrees. I made some prop stick extension from PVC pipe. The pipe simply slips over the window's existing prop stick. On the other end of the pipe I added a 45 degree elbow that I cut down into the shape of a tab. The tab slips into the existing window frame notch. Not sure I'd leave this set up in gusty winds, but...





The rest of my dumb ideas are at...

http://www.jeff-z.com/rv/amods/amods.html

I like this idea. May try it. I was also thinking of getting latches like the ones that would hold the legs of a tv tray or similar table open. Thanks for the pvc idea.

Jeffzee160 wrote:
The rest of my dumb ideas are at...http://www.jeff-z.com/rv/amods/amods.html

Thanks. Lots of innovative ideas listed there, and nicely written up and illustrated.

I use the notch in the red handle also. Unfortunately there is no half open position. It is all or nothing.

I did something similar to that except I put a portable 5k air conditioner in the escape window with a PVC pipe in the window arm to the ground to hold the window up.

I use a rubber band on the window arm to keep it half mask or partially open instead of all the way open.

This thread gave me an idea. I couldn't use baggage door latches because my window hinges don't swing up past 90 degrees. I made some prop stick extension from PVC pipe. The pipe simply slips over the window's existing prop stick. On the other end of the pipe I added a 45 degree elbow that I cut down into the shape of a tab. The tab slips into the existing window frame notch. Not sure I'd leave this set up in gusty winds, but...





The rest of my dumb ideas are at...

http://www.jeff-z.com/rv/amods/amods.html

Jerry9n wrote:
Not sure what kind you have but mine had no notch so I drilled a hole and used a small pin. Also drilled a hole in the clip that holds it closed (heard of these coming loose while on the road).

Not picking on you Jerry, but if the posted photo is your window the notch we are referring to is there on the bottom of the red handle. Here's your picture with an arrow pointing to the notch.


You just open the window and let the notch in the bottom of the handle lock onto the window frame. I do like your pin idea to keep it closed. There's no chance it's going to accidentally pop open that way. :)

I'm not sure what kind you have either. Mine have 2 latches , one on each side, that you pull to release. All I have been able to come up with so far is a couple of small pieces of wood cut to length to prop the window open.

You heard right about them coming loose, I looked in my mirror one day to see it flapping up and down. Luckily no damage was done, I pulled off and put it back in place.