Atwood g10-3e question no power at switch
Atwood g10-3e no power at switch or outside at unit, but fuse is good. Does anyone know if the power goes through the switch before going to unit? Could my switch be bad? It's the type of switch wit...
Forum Discussion
wa8yxm wrote:
I can not be sure of all models but most of the Atwoods I know of have 120vac delivered to the "Rear" (inside the motor home) of the water heater, tehre is no 120 volt at all to the outside or to the switches, they are all 12 volt.
If you access the "Rear" (where the pipes connect) you will see a box, may be black plastic, or metal, it will have 3 pair of wires going to it.
120 volt in (ROMEX)
120 volt out (To Heat element)
12 volt control
inside the box is a relay
The switches tell the control board to use Gas, or to close that relay when heat is needed.
DC Relay only used on 2004 and later combination (electric & propane) models.
OP's is a 1996 vintage propane only. His issue was a loose connector
