Mounting an exterior coax connection to motorhome

Pull the side front windshield molding on what ever side you want. Usually just a few screws. One side will already be full of electrical wires so look at the other side. You really don't want to mix them. Get some RG-11 over the RG-6 and that will help.

Does it have a cable TV connection? Could use that to utilize the cable already in place. You can use a diplexer if you'd like to have cable and satellite connections both useable.

A cable would not be run from the BOMB to an antenna. That needs to run directly to the receiver. If that's where the BOMB is located as well that's fine but you don't connect that cable to the BOMB. The "output" from the receiver connects to the BOMB for TV viewing on multiple TV's.
Does your coach have wiring currently for a TV located outside in one of the bays? If so, and you are not using it you can re-purpose that cable for a run from your dish to your receiver. Let us know.

On my BOMB, there is a cable in the electrical basement bay that is to be used to hook up to RV park cable service. If you have one of the, all you have to do is connect your external antenna to that connection and push the right button on your BOMB.

I mounted one of these TV CONNECTOR weather tight boxes on my camper to use for routing my Ham Radio RG antenna cables to the outside. The TV "F" connectors are mounted in standard size holes in plastic and installing one of these connector boxes with spring lids is easy to do... Enough room here to remove the "F" connectors and use any number of the different RG feed through connectors...


Google image

Find a spot on the outside that will extend into the back of a cabinet somewhere on the inside.

Roy Ken

Mountainair, I believe you have the answer with routing behind the windshield corner post covers. I'll take a look at that. If I can do that, then I will mount something like RoyB suggested.

For clarification, the cable is going from Bomb to tailgater.

Doug

Make sure you use the proper coax or if it's a motorized azimuth antenna the coax will overheat due to resistance.

bennefim wrote:
Mountainair, I believe you have the answer with routing behind the windshield corner post covers. I'll take a look at that. If I can do that, then I will mount something like RoyB suggested.

For clarification, the cable is going from Bomb to tailgater.

Doug

For additional clarification, that's not where the coax from a Tailgater would go. It needs to go directly to the satellite receiver and the output from the receiver will go to the BOMB.

Ok, on most coaches there is a PILLAR called the "A" pillar (They are lettered starting with the front of the coach) where the windshield meets the side windows. This is usually right beside the overhead compartment

If you pop the caps and remove the screws and "Open" the pillar you will see a whole bunch of cables already hiding there.. add one more, Close, replace the screws and caps and you will have a cable under the dash.

I then went through an existing hole to the engine side, and mounted the ground block on the Brake Bell Crank Barcket under the hood. But you can then run id down the rails (Frame rails) to any handy compartment re-enter and mount a block wherever you wish.

Thanks wa8yxm! That sounds like a plan.

Doug