Water pump--No power

Success! Ordered and installed new controller and now have water. Thanks Old-Biscuit for link. I'm outta here.
! Don

Old-Biscuit wrote:

txtode wrote:
Finally found the pump controller. After exhausting every place I ( and multiple others on RV.net forum) could think of noticed that when i operated the pump switch I could hear a "click". With the help of a friend operating the switch The click was traced to the moniter for holding tanks, generator hrs and slide-out control. Removed the cover and there it was

Many thanks to all forum members that submitted their suggestions. From all that I have read this is a 'new' location for the pump controller.
Don


'99 Monaco 40' PBR

Hunting for 'things' in RVs is kinda like a scavenger hunt.....never know what you will find or where you will find it.

Now that you have located the illusive controller is it the problem?

Here is a troubleshooting guide........LINK

Thanks for the link. Have not checked the controller yet. Will post results when I do.

Don

txtode wrote:
Finally found the pump controller. After exhausting every place I ( and multiple others on RV.net forum) could think of noticed that when i operated the pump switch I could hear a "click". With the help of a friend operating the switch The click was traced to the moniter for holding tanks, generator hrs and slide-out control. Removed the cover and there it was

Many thanks to all forum members that submitted their suggestions. From all that I have read this is a 'new' location for the pump controller.
Don


'99 Monaco 40' PBR

Hunting for 'things' in RVs is kinda like a scavenger hunt.....never know what you will find or where you will find it.

Now that you have located the illusive controller is it the problem?

Here is a troubleshooting guide........LINK

Finally found the pump controller. After exhausting every place I ( and multiple others on RV.net forum) could think of noticed that when i operated the pump switch I could hear a "click". With the help of a friend operating the switch The click was traced to the moniter for holding tanks, generator hrs and slide-out control. Removed the cover and there it was

Many thanks to all forum members that submitted their suggestions. From all that I have read this is a 'new' location for the pump controller.
Don


'99 Monaco 40' PBR

enblethen wrote:
Found this. I didn't read through all the responses but it might help.
pump location 1

Thanks, this will help a lot I think. Will read the posts tonite and go looking tomorrow.
Don

Found this. I didn't read through all the responses but it might help.
pump location 1

Did not have a chance to search today. Will get back to it tomorrow.I have looked in all the obvious places, now the not so obvious. Any tip still needed.
Don

A pump controller allows for more then one location to activate the pump. The Intellitec version uses a pulse signal from a momentary switch to operate the internal relay in the controller.
The pressure switch is normally located in the head of the water pump.

enblethen wrote:
Pump controller may have failed. Could look like this one. Normally hidden around 12 volt DC panel or converter.
Pump controller

Just curious .... what is a pump controler? A pressure switch?
:h

enblethen wrote:
Mine is hid along side a set of draws in the hallway

Thanks for tip. Will check.
This is the sort of tips I need, the not so obvious ones.