Sensar Pro

There are 3 cable that hang out back side of unit. 1 antenna, 1 front TV and 1 Rear TV.

I could not be more pleased with my Sensar Pro. Tune the direction for peak signal, adjustable gain and two outputs to eliminate loss and splitters.

I more than doubled the number of channels received at my house.

ronfisherman wrote:
There are 3 cable that hang out back side of unit. 1 antenna, 1 front TV and 1 Rear TV.

Wrong, there are 4, ANT TV1, TV2, Cable in.

You do have to bring the one cable to a second plate mounted next door You can use a small metal square to mount the connector if you like.

As mentioned, there are 2 TV outs but they are both in the back of the Sensar Pro. In most cases, this is where the TV coax(es) are located and not an issue. However, if you do use and need a front output you can simply feed one of the 2 connection in the back between the wall and the wall plate and connect the coax in front. You could also drill a hole in the cabinet and install a barrel connector (if it's thin wall) to connect front to back or, as mentioned above, install a separate wall plate with a barrel connector. Both of those options would be done simply for looks as the first option works just as well.

Thanks for the fast replies. That makes more sense now. The plate is mounted on 1/2" wood wall but adding a second plate, or just running it out under the plate, isn't a problem. That's how I have my Dish connected through the cable input now.

I replaced my BOMB with the Sensar and wired everything direct when I converted to HD.
My av cab is next the front tv with one shelf about halfway up. I was in a hurry to get everything installed so "temporarily" mounted mine with 2 pcs of Velcro on the front of the Sensar cover and 2 pcs on the inside lip of the door frame. Works so well I am leaving it and I can rip it out if and when I need to.

wa8yxm wrote:

ronfisherman wrote:
There are 3 cable that hang out back side of unit. 1 antenna, 1 front TV and 1 Rear TV.

Wrong, there are 4, ANT TV1, TV2, Cable in.

You do have to bring the one cable to a second plate mounted next door You can use a small metal square to mount the connector if you like.

Been a couple of years since I did mine. CRS does not help.
Here is a link to the SensorPro on Winegard site. Click on manual to see how to wire it.

Only been about a year since I did mine.. I do not (At this time) have anything hooked to the cable connection since one of the outputs feeds a box of many buttons.

Thanks again for the replies. Think I'll be installing one in the near future. Probably going to wire the outside cable input to a separate connector as my Dish receiver doesn't seem to like going through the plate I have now.

You will also not be able to use an outside cable connection to power a satellite antenna if you use the Sensar Pro. However, you can add an A/B switch to that coax end where your current power supply is (or where the Sensar Pro will be) and send one output from the A/B to the Sensar and the other output to the satellite receiver and that will allow you to use the one cable or the connection of your choice.