OK so i bought this saggy old 91 bounder thats 40ft long with a 16ft slide. After changing the engine that blew up the day we bought it (gas 460) to another way newer and less miled out one that runs great now, the next task was to address the Mor R...
1991 Fleetwood Bounder Special Edition, 40feet long with a tag axle out back.The weird part with this tag axle setup is that it uses the bloody mor-ryde system but its a pivoting arm that supports both axles.I would say the rear end is sagging a good...
Hey peoples, we have a 40 foot 91 fleetwood bounder MH. It has the touchpad HWH auto levelling system on it.The jacks seem to work fine but on the back 2 jacks the little wires are broken where they go into some sort of sensor.Ive tried googling thi...
Well i cant find safety blankets here in this small city so i will have to do some online shopping.Other then that the bags are holding air properly and the MH rides so much better now.
Thats correct, when this frame left the factory it was a single axle on leaf springs, fleetwood ripped it out and added a tag axle setup but kept the drive axle thats bolted to the pivot setup. It's the weirdest setup ive ever seen.
ya the engine swap was a major pain in my backside but its done and running perfectly now. According to that page they only rate it for a total of 2732lbs of people and stuff including a tow vehicle. I would say thats almost impossible to stay with...
