My refer seems to work perfectly on propane but doesn't work at all on electricity...neither one the generator or while plugged in. I have 120v at the refer's receptacle so I know it's getting power. Any suggestions?DometicModel# RM2852Product# 921 1...
2001 Fleetwood Flair V-10Transmission skipping / slipping / short shifting, overdrive button light blinking, service engine soon light on and I'm getting the following code:P0720 - Output Shaft Speed SensorHere's a brief story behind this...About 5 y...
2001 Fleetwood Flair 30H, Ford V-10 chassisWhile inspecting underneath I found a broken or chewed through wire and I can't seem to locate the termination points. It's a single brown wire...it comes up through the floor above the rear driver side fend...
Well, the good news is I found the problem...the bad news is I need a new board at the very least. WOW! It looks like I need a Dinosaur Micro P-711 for replacement...but I can't help but wonder what would have caused this failure? I hate to put a new...
Thanks for all the help everyone..This site is awesome and you people are awesome!"If it switches to electric but the element doesn't get hot, odds are the element is bad."It does seem to switch to electric mode...just won't cool.Chris - Thanks for t...
wrgrs50s wrote:I had this problem and traced down where the 120volt power cord plugged in to the circuit board and found that the spade connection was not pushed all the way on to the circuit board. I pressed on the spade and heard and felt a little ...
Ranger Smith wrote:The 120 volt element or the fuse on the board is bad.I checked the fuse and it was good but I replaced it anyway. Where is the 120v element and what does it look like?Thanks a bunch Ranger!
