I am in the process of repairing the bedroom slide and thought I would seek out some advice of some of you experts. I had extensive rot in the outer 10" of my slide. I cut out the bad portion and yesterday routed a 1 1/2" joint in the good part of th...
There is another active thread regarding converter sizes, but I get lost in the wealth of detail offered here. I have a simple question: I have a PD 9200 , 45 amp converter, two Trojan T105 batteries and a Honda 2000w generator.With my setup, should ...
I just installed A TPMS System and noticed that If I leave the monitor turned on and leave my trailer, the monitor continues to report the last temperature and pressure it received when I was hooked to the trailer.This is telling me that when towin...
looks like a terminal block. But, some are hot and some are not. The one feeding the hydraulics for my slide is not hot and the slides won't work. I always thought they were circuit breakers but no,way to reset them. I have a nice picture but I am no...
I have experimented with several different types of caulk and recently gone back to using GE window and door silicone. Seems pretty easy to work with and looks good. I believe all manufacturers use silicone. What does everyone have against it?
The metal strips for the rollers is a good idea and that is what i did when I first noticed the rollers digging into the underside. The metal strips collasped because of extensive rot in the slide. The problem now is repairing the rot. Drain holes wi...
When I had a bumper pull I built a rack for my kayak that went over the roof of the pickup and out over the bed. I check my milage pretty closely and did notice a slight improvement with the kayak on top. I am guessing that it broke up the airflow fl...
Just received my pendant for my PD 9200.I am pretty happy with what I see now. It It will allow me to put the coverter into boost mode and I get a reading of 14.4v (or 14.6v, dont remember which) at the battery. So I am happy that my wiring is ample ...
Ok. The volt meter I have been taking reading from is measuring at the battery.I do have a digital hand held volt meter and hydrometer.Can I expect my t105s to go from 11v to 90% charge in a couple of hours?
