1998 Discovery water pump Latching Controller

[Discovery_Dave]

I am trying to find to replace the interior water LATCHING CONTROLLER. I have been told this should be my problem on why the pump has no power.I know what it looks like. I have looked throughout the compartments inside and out. Any help. Fleetwood has not responded after receiving the FIN number.

[OnaQuest]

Discovery Dave wrote:
I am trying to find to replace the interior water LATCHING CONTROLLER. I have been told this should be my problem on why the pump has no power.I know what it looks like. I have looked throughout the compartments inside and out. Any help. Fleetwood has not responded after receiving the FIN number.

The controller does not actually "power" the pump. The controller only applies ground to the pump. The "power" is hardwired (through a fuse) to the hot side.

If you have no "power" to the pump, you could have a blown fuse or a broken wire as well as a defective controller. If the fuse is blown, you will not have any lights (if your switches are lighted like mine) or action from the switches.
Here's a LINK to the controller Document.

Here's a sketch of the pump circuits.

[enblethen]

Mine is located in hall way. I have to pull out the draws and it is mounted along side them.

[OnaQuest]

Mine, on an older Bounder, is located near the pump. I have heard that some are behind the circuit breaker panel or under the refer. It won't be out in the open in a storage bay. It's not much larger than a deck of cards, so can be most anywhere.