โSep-03-2022 05:32 PM
โAug-12-2023 10:34 PM
enblethen wrote:
Have you measured the distance between the rubber bump stop and the crossmember. min of 1.5 inches?
I see blue springs. Are they variable rate replacements? If they are, was the rig weighed prior to ordering? if not variable rate, you need to install the air bags which rig should have had when new.
โOct-02-2022 10:15 AM
Bud
USAF Retired
Pace Arrow
โOct-02-2022 12:55 AM
โSep-08-2022 03:46 AM
fyrflie wrote:
A little off topic but when you replaced your springs, did you have the front end aligned to SuperSteer specs.
It made a world of difference in my P32.
โSep-07-2022 08:51 AM
โSep-07-2022 06:02 AM
Bud
USAF Retired
Pace Arrow
โSep-07-2022 04:46 AM
enblethen wrote:
I believe I commented on the fact the end bushings were split and the center one is full. I think you installed in wrong positions.
โSep-06-2022 07:34 PM
Bud
USAF Retired
Pace Arrow
โSep-06-2022 03:39 PM
โSep-04-2022 02:00 PM
Bud
USAF Retired
Pace Arrow
โSep-04-2022 01:49 PM
enblethen wrote:
Bushing could be deformed by slop in other front suspension components such as A-frame bushings or ball joints. A-frame bushings could be ovaled out.
OP: glad to see other components like springs and bell cranks are great quality.
โSep-04-2022 08:35 AM
Bud
USAF Retired
Pace Arrow
โSep-04-2022 07:52 AM
rgatijnet1 wrote:
To me it appears that the bushings are for a sway bar with a larger diameter than yours.
โSep-04-2022 05:46 AM