Replacing 921 to leds.

[reefaddiction]

Hello,
I'm new to these forum I looking for some info I have a 2012 Jayco Bungalow I'm looking to replace out those interior 921 bulbs that get hot for some leds and I was wondering does anyone have a info on that. I have been looking on ebay and other sites and they have 280 lumen bulbs or led boards? I see they are in 4000-4500k if I'm correct is that going to have a blueish tint? Any advice or products you guys could recommend would be great. Scott

[CT_WANDERER]

I just installed the LED's that milo and mena661 are referring to and very happy with them during my test. I have not done any overnight's with them yet, but my amp load is way down.

[mena661]

milo wrote:
Checkout this 921 LED www.ledtrailerlights.com/rv/RV-T10-wedge-252.htm

I've used these. Great LEDs. They used to have a 380 lumen 921 LED. I had a few of those. Very bright but warm.

[milo]

Checkout this 921 LED www.ledtrailerlights.com/rv/RV-T10-wedge-252.htm

[Bill_T]

check out the led's at www.technorv.com.

[tenbear]

Before you buy many lights, buy 1 or 2 to see if you like the color, brightness, etc. I have found that sometimes the descriptions on eBay are not always accurate.

[JiminDenver]

You can see how I and some others have done it here clicky

[vermilye]

2800°K - 3200K is the range of a typical incandescent lamp, so they will be a little cooler than what you have now, however things don't start turning blue until you get over 5000°K - 6000°K, the typical color temperature of a fluorescent lamp.

A 921 is rated at 264 lumens, so it should be about the same brightness.