Testing with a multi meter across the ground pin and the trailer brake pin at my seven way connector on the truck, I get no voltage when the prodigy P2 is manually activated.Question number one… Is there a fuse on the truck that I should check?Questi...
I have a Tekonsha Primus brake controller which was installed in my truck when it was new in 2005. Lately it seems like it's not stopping my trailer like it should, even with the gain turned all the way up. I adjusted the brakes themselves and it hel...
We've just started carrying the Cummins/Onan portable generators (2500 watt and 4500 watt) here at Camping World and they look like great units. Comparable noise levels to the Hondas, with more features and quite a price differential.My question is ....
I'm trying to build an extended run fuel system for my Champion Digital Hybrid (Model #100302), but can't find the replacement gas cap. Anyone have any links to one?
I'm not sure if this is the proper forum and if not, I trust the moderators to move it . . .My 2018 Vintage cruiser came stock with a 13.5 K BTU Non-ducted Coleman A/C which is SO loud you can barely carry on a conversation or hear the television whe...
Reader1 wrote:There are dangerous pranks I read about today on RV quilters facebook page. Both happen at night. "Kids" go around closing the bar that goes in front of doors. Doing that makes it nearly impossible to open the door. Kids are also clo...
So here are my results:Running my camper with fridge on LP and water heater on LP, I fired up this generator about 9pm. Running the A/C (Atwood Air Command with a MicroAir soft start kit) Overnight lows in the upper 70's with the thermostat set at 75...
4x4van wrote:At 15 years old, I'd be checking the brake shoes & magnets as well.The brake controller is 15 years old... The trailer is only 3. Still, I'm gonna pull it around to the driveway and give all the wiring a once-over.
bobsallyh wrote:A dealer had them at Quartzite, AZ. last winter at the "RV Show'. Look at the box, memory serves me correctly it said "engineered and designed by Onan/Cummins in Indiana. Made in China. The 2500 was sitting there just purring away unt...
Thanks for all the replies .... I just replaced the 7way pigtail, so I'll check that ground, along with the wire connections. Also, replaced and relocated the 7-way on the truck side, so I'll recheck all that. Thanks again.
