I have this B/W monitor in my motorhome and I need to know how to adjust the horizontal hold. The picture keeps going wonky like an old black and white TV. On those there was a knob to adjust.
I need to find a OBD2 scanner that will show misfire info on my Workhorse W22. The one I have is a Actron CP9575 that doesn't show hardly anything except when I have a engine code. It seems to have provision for misfire monitor but is listed as N/A ...
I have a recently purchased motorhome that I can't drain the hot water heater. I took the plug out and there is an anode in the hole that has broken off the plug. I got a hold of the centre wire with visegrips and pulled to no avail. Looks like lots ...
I purchased the newest Garmin RV GPS RV 760lmt and am fairly disappointed . They have done a very poor job of providing roads that are RV accessible causing one to drive many miles out of your way if you were to follow it. I often had to change to au...
Thank you for all of the suggestions. Does the ScanGauge II show data for individual cylinders? I checked their manual and I couldn't find any of that information.I am also very aware of the spark plug wire problem on the 8.1 Vortec engine.
This is the 2003 Monaco w/ 10 gal heater. The anode was put in before I bought the motorhome and it looks like the previous owner had this problem (among other things) and traded it off. I guess the dealer never tried to drain the heater either befor...
Thanks for all of the tips on how to repair this. I managed to drill it out, started with a small bit and driilled most of the center wire, then went bigger and bigger till there was only a small amount left. Was able to pull it out Borrowed a 1/2" ...
It is an anode rod and not a hot rod. It has the steel wire in the centre like all the aftermarket ones you see for sale at RV parts stores for Attwood water heaters. I have been squirting CLR around it and pulling on the steel wire with visegrips. I...
