need to replace my marshall 605h propane regulator. seems like they have been discontinued. anyone know of a direct type replacement for it? thank you.
same old story. my fresh water monitor always reads full. i cut the ground wire at the tank and connected to chassis and it still reads full so i assume its not a ground wire. all my wires connect to each other with the black gray and fresh runnin...
i am trying to find this thermally conductive epoxy that was posted on this forum about 6 months ago for a hot water heater adjustable thermostat. i have messaged a few people that were on the topic but they have not responded, so i thought i would ...
MEXICOWANDERER wrote:CLEAN! SPOTLESS!Please give feedback as to how this all works out for you...works great, i can control the temp of my water and turned it down cuz i hate burning my hands with the hot water. dont care about the efficiency of hot...
u didnt read my post. i said i was running the fan wire down the drain tube which means i have a small computer fan in the fridge. no one mentioned anythingabout vent fans. ps..the ground wire is attached to the fan which is attached to the cooling...
already got a frig fan on ebay, I am going to run the hot down the drain tube to get the hot wire. does anyone know where there is a hot wire on the outside of the frig in the back? thanks. pics?
westend wrote:I would guess the fresh water tank sensor wires, themselves, are the problem. Run a new wire of similar gauge from the tank wires to the indicator panel to check for diagnosis.easier said than done. all the wires up into the rv thru th...
even went further today. the tank still reads full with all the wire off the tank and just hanging. so i assume the panel? or is there some type of resistance from the other wires on the other tanks since they are all wired together? thanks
