I have the Itasca detailed below, and lately has developed an issue where the dash fan will only work on the high (noisy!) switch setting. After starting the engine (Chevy workhorse 8.1 engine chassis) it sometimes will work on the lower settings, bu...
I have a 2003 Itasca 27 class A that has a rear heater under the bed. I'm trying to figure out how this thing works (it does work when driving). It has electrical wires running in to it and seems to have water lines (from the hot water heater?) goin...
On my 2003 Itasca 27 Sunova, one of the plastic storage compartment latch "receivers" (for lack of a better term) is bent, so one side of the compartment won't latch closed (I'm talking about the "door jam strike plate" portion of the latch attached ...
I have a 2003 Itasca Sunova 27 and the rear center brake light (which is a red LED strip about 10 inches long) was only partially working (only half would light up). I bought a new one online as a replacement, but when I took off the old light, I fo...
The 2003 Itasca 27 MH I bought came with a Roadmaster Falcon All-Terrain towbar and an Evenbrake unit, but nothing else to go on the toad. So I bought the correct cross-bar and base-plate attachments, and an Evenbrake second-car kit to install the ...
We went on a short trip this past week, and lo and behold the fan seemed to work just fine. All speeds worked as they are supposed to. Of course this was right after I had orderd a new dash fan switch! So now I have an extra resistor assembly and f...
We took a trip this week and I verified the water was not hot after more than an hour of driving. My Atwood model is GH6-8E which according to the interwebs does support motor heating. So what coolant temperature is spec for the Chevy Vortec 8.1 en...
I'm also in the SF Bay area and found public weighing stations in Oakland and in Sonoma, and that was about it! Check online for public scales. I had my two axles weighed at the Sonoma location for about $35 while we were headed up to Sugarloaf Ri...
OK...I tried a new resistor assembly, and that did not fix the problem. As I note above, it seems that there was voltage to the resistor regardless of the switch position, but I've gone ahead and ordered a new switch....hopefully that will do it!(An...
dougrainer wrote:The Hot water runs thru the Water Heater loop all the time. You do NOT have to turn the Water Heater ON. You CANNOT even turn this heat function OFF to the Water Heater. DougThat probably explains why my RV runs pretty cool most of t...
