happycamper002 wrote:Bad advice and even irresponsible.Installing fans and wires in either end of heat vent violates fire safety codes. You can't (well you can but you shouldn't) run electric wires inside heat vents and duct works. If wire insulation...
In my experience, wheel bearings that are loose (to a certain point) will run a lot longer than bearings that are too tight. The quickest way to ruin a tapered roller bearing is to overtighten it.
hedge wrote:What's the difference between a backup and a rear-view camera? I use mine for both, it comes on when I switch into reverse but I can also turn it on with an upfitter switch.I have a wireless Garmin BC30 and it's pretty decent.When you tu...
Let us know how well you like it after you swing your front fender into the tree, fence, etc because you were so focused on the knob & rear view camera.
New brakes must be properly burnished for optimum performance. Perform the procedure as described at the bottom of page 16 in this Dexter Axle manual. It made a HUGE difference on my 5er.http://www.dexteraxle.com/i/u/6149609/f/600-8K_Service_Manual/E...