My furnace is an older hydro flame 8531-II. the gas valve is not functioning so I was going to order a new one. But it appears that part number 31155 is no longer available. Does anyone know if the gas valves are more or less the same? I found one th...
I’m rebuilding an old travel trailer and need a new water heater. Assuming I could make either fit, would you prefer a 10gallon or should I stick with the 6 gallon?Thanks!Bob E.
My dad's 10yr old Norcold Fridge quit working in his camper. It runs but doesn't cool at all on either gas or 120v electric. Opened the outside cover and you can see some green residue in the corner of the opening under the right side where the hea...
What's the typical length and drop of the beaver tail in the back of toy haulers? I'm sure they vary, but was just wondering what is typical.Thanks!Bob E.
My dad's camper (Jayco Eagle TT) has both a "cable" and a "satellite" hookup on the outside of the camper. What's the difference? I can't figure out why you would need both??
I have the Predator 3500 from Harbor Freight and it will run a single 15k AC unit easily. You can parallel it with another unit to run 2 AC's and the cost per generator is pretty reasonable, especially compared to similar Hondas. And it has good re...
2oldman wrote:Bob E. wrote:but you can count me as one of them.Of course, I'm not saying 'nobody' does, it just seems quite rare compared to the number of people on here who want a generator to run their air. Then again, perhaps I only run into peopl...
2oldman wrote:A bit off topic, but in all my 15 years of boondocking I can count on less than one hand the number of RVers running air from a portable generator, even in 90+ weather.Not sure how many extra fingers you have, but you can count me as on...
Thanks guys! These photos and information have been very helpful. I ordered the newer gas valve (#31098) because it looks like it has the gas inlet and outlet ports in the correct place (or at least close to it). Supposed to be delivered Thursday....
BFL13 wrote:Here are three photos of what goes in an 8531-II or III. It appears the gas valve is part of this assembly. 25M16V Type 701 is marked on it as shown.Yeah…that’s exactly what mine looks like. I’m actually rebuilding my camper from scratch...
