I’m having problems with my Atwood 8531-IV furnace. It will not ignite. The fan runs for 30 seconds then stops for a few seconds then starts back up and will do this over and over but I do not hear the gas valve clicking or the electrode sparking. I’...
Hello everyone I have a question about my power awning. It will only work when I use the power cord with the alligator clips attached to the terminals near the motor. When I try to hook up the original switch the way it was when I took it apart it ju...
Hi everyone I hope someone can help me out with my installation of the replacement Fasco ac motor I just purchased. My original motor had bad bearings and froze up. I purchased the exact motor only newer since the original is from 2008. The original ...
Well we're about 1500 miles into our first ever RV adventure which has been great but our propane system isn't working well. We have a 2013 14rb AR-ONE. The problem we are having is that the propane won't continually flow over a longer than 10-15 min...
Hello. I just purchased my first TT two days ago. It's an AR ONE 14rb 2013. Today I wanted to open up the windows to air it out due to the hot weather and noticed water on the floor coming from the toilet. Upon further investigation I noticed it was ...
So I bit the bullet, removed my furnace and took it to a RV Technician. He preformed a bench test on it and was able to see everything working well. He said he blew out the combustion chamber and the connections with air but that was all he had to do...
Ok so I checked the Sail Switch with a voltmeter. When I turned on the furnace and the fan was running I had 12 volts, (12.97v) on one side of the Sail switch. I checked the other side with the switch physically pushed with my hand to simulate the fa...
Thanks for the response dougrainer and topjimmy! I m heading out to get a voltmeter then I will check the voltage in and out of the new sail switch I have already installed.
I’m not sure if my model furnace has one of those relay delay’s on it? I only saw a reset switch other than the board and nothing attached to the outside of the fan housing where other models have it attached.
