I suffered a pretty good scratch on the side of our Raptor 398TS with full body paint. A quick internet search did not come up with much. Anyone here have any insight? I have heard Keystone was not to great on providing color codes.
Looking ahead to our next hauler we really like the Voltage line but very few if any older models came with a king bed. Has anyone converted their Voltage to a king bed in the master suite? It looks fairly straightforward like you would have to reduc...
Has anyone performed a de-lamination repair themselves? How did it go? Which kit did you use? Has anyone repaired a large crack in their gelcoat siding? Any instructional videos you could steer me towards?My 2006 3612 has delam on both rear corners. ...
I have a Dometic 8500 series awning on my Raptor 3612. I am looking to convert it to electric. Has anyone here done this? Just looking for insight, etc...
I am looking for other Raptor 3612 owners that have swapped out the booth style dinette for table and chairs. If anyone has done this can you please post some pictures so I can show my wife?
y-guy wrote:The area that is tapes off is the air outlet, so without that tape the hot air is being pushed to the door. Get some heat tape and recover it.Yep. Onan tech support told me the same thing after looking at that diagram. Thanks for the info...
The black cover which is most important is tight and sealed well. The gasket on the bottom which you guys may be referring to is for the compartment door which came unglued from the heat over the weekend. I believe I have the install manual and will ...
lincster wrote:Why is the genny sitting on foam?I would be concerned about that.That foam will hold heat.It is not. It looks that way from the pic. The foam is the seal between the generator enclosure built into the compartment and the compartment do...
Been lurking here following this thread. I have a similar question but different hardware. I have a Kuerig coffee maker that brews one cup at a time. The initial warm-up lasts around or under 3 minutes drawing 1500 watts. The water tank re-heat cycle...
Thanks for the input everyone. I got the trailer in the shop today and once I cut the u-bolts and took the load off the suspension I found the problem. All of the suspension bushings were worn out. Some worse then others. I ended up replacing both re...