Hi,
I did a fair amount of research on Class C's and A's about that time, as we were in the market to buy our first RV....which we still have. So, the moral of the story is if you do your research before you buy, it can really pay off in the long run.
Anyway, rigs of that size on the E-450 chassis with a slide (I believe that model had a slide) were very easy to overload Ford's chassis weight ratings, especially the rear axle weight rating and the gross vehicle weight rating. This bothers some people, and doesn't seem to bother others. I knew I was the type it would bother, so I passed on this and similar long E-450 based class C's with slides. If you do not know about the weight ratings, that is an area you owe it to yourself to do some research on. It seems ironic, and probably is, but there were various rigs of this type which came from the factory with the rear axle almost at maximum rated load capacity with just the fuel and fresh water tanks full, yet still have cavernous storage bay space available. Unfortunately, if you put anything other than feathers in it, you'd be overloaded. Again, buyer beware. Putting more weight behind the rear axle leverages weight off the front axle, and that can lead to handling problems. Perhaps THAT is why the mileage is so low? They were afraid to drive it! Best bet: Take it out on a test drive to a CAT weigh station and get the front and rear axle weights with full fuels and water tank, THEN see how much capacity you have left for people, food, clothes & stuff.
Someone mentioned tires over 5 years old as being ready to be replaced. I don't agree with that, necessarily, BUT on a rig you don't know the history of, it wouldn't be a bad idea. (I went 12 years on the tires on my class A without issue. BUT I knew they're history, I knew they'd never been run under inflated or over loaded, or subjected to any real road hazards.) Most people use 7-10 years as a guide to replace tires which have had decent & known care.
Low hours on the generator can commonly lead to carburetor issues due to the fuel remaining stagnant in the float bowl and carb parts. This tends to put a coat of "varnish" over the small passages and cause problems. Again, something that would be a good idea to become knowledgeable about.
I can't really comment on the price, though I might think it to be a bit on the high side, but IF it was clean, no leaks, fully serviced, new tires & batteries, and in EXCELLENT shape, it might not be a bad deal in your market, IF you were OK with the potential weight issues.
Good Luck in your search,
~Rick
P.S. I believe in some of your previous posts (in the class B forum?) you mentioned that size (too small) was an issue and that you were hoping to keep the length under 30'. Since you're already looking at units longer than 30', if I may, I might suggest you include gas Class A rigs up to about 36' in your search. It will give you MANY more units to look at, with the majority of them, you won't be as likely to have over-weight issues, you'll have much larger storage areas, holding tanks and that extra 4-6' of interior space is nice. PLUS the driver & passenger seating area becomes part of the living area when parked. Just something to think about. Obviously, for us, that is where our research led us, and 13 years later, we're still very pleased with our rig. Good Luck.
๐
2005 Georgie Boy Cruise Master 3625 DS on a Workhorse W-22
Rick, Gail, 1 girl (27-Angel since 2008), 1 girl (22), 2 boys (23 & 20).
2001 Honda Odyssey, Demco Aluminator tow bar & tow plate, SMI Silent Partner brake controller.